5 PC. SCREW EXTRACTOR SET
Any product images shown are for illustration purposes only and may not be an exact representation of the product. Please check with Bolts Plus prior to ordering to confirm specifics including (but not limited to) thread length and plating colour.
Details
Drill a Hole: Use a left-hand drill bit to drill a hole into the broken stud. Left-hand bits are designed to turn counterclockwise, which can sometimes help loosen the stud as you drill. Make sure the hole is centered and deep enough to accommodate the extractor.
Seat the Extractor: Place the extractor into the drilled hole. The extractor should have a reverse thread, which means it will grip the broken stud when turned counterclockwise. Tap the extractor lightly with a hammer to ensure it's seated firmly in the hole.
Turn Counterclockwise: Use a tap wrench or another suitable tool to grip the extractor. Turn the wrench counterclockwise (lefty-loosey) to begin loosening the broken stud. Apply steady, even pressure as you turn.
Be Patient: Sometimes, removing broken studs can be a slow process, especially if they're rusted or stuck. Avoid using excessive force, as this can break the extractor or make the situation worse. Instead, apply penetrating oil or heat to help loosen the stud if necessary, and continue turning gently until it's fully removed.
Inspect and Clean: Once the broken stud is removed, inspect the hole to ensure there are no remaining fragments or debris. Clean the area thoroughly before proceeding with any repairs or replacements.
Remember to wear appropriate safety gear, such as gloves and safety glasses, when performing this task. Additionally, if you're unsure about any part of the process or if the broken stud is particularly stubborn, it's always a good idea to seek professional assistance to avoid causing further damage.